1.22英寸TFT液晶显示屏 240*204 亮度300 SPI接口 IC型号:7789

1.22英寸TFT液晶显示屏

加工定制

是

品牌

AMELIN
型号	Z12004B1MV
种类	TFT型液晶屏(模块)	屏幕尺寸	1.22（英寸）	色彩	262K
亮度	250	对比度	250:1	分辨率	240*204
像素	204p	点距	0.22（mm）	响应时间	25（ms）
General Deion
??1.22”(diagonal),240 RGB x204dots, 262k colors, Transmissive, TFT LCD module.
????????Viewing Direction: IPS.
????????Driving IC: ST7789V
????????4-line SPI data bus (Serial interface)
????????Logic voltage: 2.8V (typ.).
Suggestions for using LCD modules
11.1 Handling of LCM
1.The LCD screen is made of glass. Don't give excessive external shock, or drop from a high place.
2.If the LCD screen is damaged and the liquid crystal leaks out, do not lick and swallow. When the liquidis attach to your hand, skin, cloth etc, wash it off by using soap and water thoroughly and immediately.
3.Don't apply excessive force on the surface of the LCM.
4.If the surface is contaminated ,clean it with soft cloth. If the LCM is severely contaminated , useIsopropyl alcohol/Ethyl alcohol to clean. Other solvents may damage the polarizer . The following solvents is especially prohibited: water , ketone Aromatic solvents etc.
5.Exercise care to minimize corrosion of the electrode. Corrosion of the electrodes is accelerated by waterdroplets, moisture condensation or a current flow in a high-humidity environment.
6.Install the LCD Module by using the mounting holes. When mounting the LCD module make sure it isfree of twisting, warping and distortion. In particular, do not forcibly pull or bend the I/O cable or the backlight cable.
7.Don’t disassemble the LCM.
8.To prevent destruction of the elements by static electricity, be careful to maintain an optimum workenvironment.
- Be sure to ground the body when handling the LCD modules.
- Tools required for assembling, such as soldering irons, must be properly grounded.
- To reduce the amount of static electricity generated, do not conduct assembling and other work under dry conditions.
- The LCD module is coated with a film to protect the display surface. Exercise care when peeling off this protective film since static electricity may be generated.
9.Do not alter, modify or change the the shape of the tab on the metal frame.
10.Do not make extra holes on the printed circuit board, modify its shape or change the positions ofcomponents to be attached.
11.Do not damage or modify the pattern writing on the printed circuit board.
12.Absolutely do not modify the zebra rubber strip (conductive rubber) or heat seal connector
13.Except for soldering the interface, do not make any alterations or modifications with a soldering iron.
14.Do not drop, bend or twist LCM.
11.2 Storage
1.Store in an ambient temperature of 5 to 45 ?C, and in a relative humidity of 40% to 60%. Don't exposeto sunlight or fluorescent light.
2.Storage in a clean environment, free from dust, active gas, and solvent.
3.Store in antistatic container.