产品规格: | 不限 | 产品数量: | 不限 |
---|---|---|---|
包装说明: | 按订单 | 价格说明: | 不限 |
查看人数: | 112 人 | 本页链接: | https://info.b2b168.com/s168-143896369.html |
防水材料选择
金属屋面长期暴露在户外,受**条件的影响很大,所以彩钢屋面防水处理必须要吻合金属建筑物的特征,所选防水材料应具备以下性能:优的弹性和抗断裂拉伸强度(手机网站制作),以适应屋面的各种震荡和位移;低温柔性;优的耐候性;抗紫外线老化;优的透气性和呼吸性;优的适应各种天气的特征,使用的温度范围较大,以保证产品在高温及低温下的性能,以及温差和骤冷骤热的要求:对各种异形不问要能做到无缝处理;安全环保等。
目前广泛应用的兼具以上特点的卷材重要有:PVC、TPO、EPDM等高分子防水卷材。沥青类防水卷材因沥青的耐候性和抗紫外线性能等缘故原由,这里不作介绍。
屋面防水翻新工程中所用的涂料以都以屋面**的DOW纯丙烯酸类为主,依仗**的粘结强度和高反射、耐紫外线性能,美莎屋面涂料已在大量屋面维修中应用及实践,10多年的市场推广应用,已被行业及客户认可并。
屋面防水做法步骤
1、基层处理
检查找平层地面的质量及干燥程度并加以清扫,符合要求后涂刷基层处理剂,确保涂刷面积大小能满足当天施工需要。涂刷完毕4小时后即可铺贴卷材。
2、施工工艺流程
基层表面清理、修补→涂刷基层处理剂→节点处附加增强处理→定位、弹线、试铺→铺贴卷材→收头处理,节点密封→清理、检查、修整→保护层施工。
3、施工顺序
防水层施工时,应先做好节点、附加层和屋面排水比较集中部位的处理,然后由屋面低标高处向上施工。铺贴天沟、檐口卷材时,宜顺天沟、檐口方向以减少搭接。施工中按先高后低、先远后近的原则施工。
4、搭接方法
铺贴卷材时采用搭接法,相邻两幅卷材的搭接缝应错开,钢屋架处坡屋面的搭接缝顺流水方向搭接,垂直于屋脊方向的接缝顺主导风向搭接。
屋顶防水涂料的三步小妙招
1、应先对下层进行处理。去除原有的防水材料,把浮土水泥清理干净,要求外观平整干燥。
1, should be the primary treatment. The removal of the original decoration materials, the cement surface clean,水性彩钢瓦漆多少钱一桶, smooth surface drying requirements.
2、铺贴屋顶防水涂料。在做屋顶防水处理的下层上刷一层屋顶防水涂料,铺一层防水聚酯布,然后再重复涂刷一次防水涂料,完全干燥后再整天涂刷一遍屋顶防水涂料,山东彩钢瓦漆,屋顶防水处理才算做完。屋顶防水涂料应刷均匀,防水布与屋顶防水层封闭精密,不能有漏刷,起鼓和脱落的征象,否则会影响屋顶防水结果。
2, paving waterproof coating. On the basis of a layer of waterproof coating, a layer of non-woven fabric, and then repeat the brush once, and finally in the second layer of non-woven fabric on a waterproof coating,彩钢瓦漆用什么样的好, waterproof treatment is done. Waterproof paint should be uniform brush, non-woven fabric and waterproof layer closed tight, can not have the leakage brush, drum and off phenomenon, otherwise it will affect the waterproof effect.
若选用聚氨酯做屋顶防水涂料,一般不用加防水布,只要反复涂刷2-3遍就可以了。由于聚氨酯涂料自己可以形成弹性的保护膜,具有肯定的耐拉力性能。为了进步屋顶防水结果,可以铺贴一层聚酯布,但费用会有所增长。
If the use of polyurethane waterproofing paint, generally do not add non-woven,彩钢瓦漆掉了怎么处理好, as long as the repeated brushing 2-3 times on it. Because the polyurethane coating itself can form a flexible protective film, has a certain tensile properties. In order to improve the waterproof effect, can be coated with a layer of non-woven fabric, but the cost will increase.
3、做“蔽水”实验,蔽水试验是检验室内屋顶防水质量的紧张检测手段。在屋顶防水工程做完后,封好门口及下水口,在室内蓄满水达到肯定液面高度,24小时内液面若无显明降落,即为合格。
3, do 'water' experiment, water test is an important means to test the quality of indoor waterproof detection. After the completion of the waterproof project, sealed the door and the mouth, filled with water in the room to reach a certain height of the liquid level, within 24 hours without a significant decline in the surface, that is qualified.
蔽水试验完成后,在屋顶防水涂料层上再做一层水泥砂浆保护层,细致不要破环已做好的屋顶防水涂料层。等水泥砂浆保护层干透后,就可以在上面铺贴墙地砖或喷刷涂料,进行正常的装饰装修了。
After the completion of the water test, make a layer of cement mortar protection layer on the waterproof coating layer. After the cement mortar protective layer is dry, it can be used for paving the floor tile or spray paint on the top, and it can be used for normal decoration.