产品规格: | 不限 | 产品数量: | 不限 |
---|---|---|---|
包装说明: | 按订单 | 价格说明: | 不限 |
查看人数: | 14 人 | 本页链接: | https://info.b2b168.com/s168-138567691.html |
水泵是输送液体或使液体增压的机械。它将原动机的机械能或其他外部能量传送给液体,球铁混流泵销售价,使液体能量增加,主要用来输送液体包括水、油、酸碱液、乳化液、悬乳液和液态金属等。
也可输送液体、气体混合物以及含悬浮固体物的液体。水泵性能的技术参数有流量、吸程、扬程、轴功率、水功率、效率等;根据不同的工作原理可分为容积水泵、叶片泵等类型。容积泵是利用其工作室容积的变化来传递能量;叶片泵是利用回转叶片与水的相互作用来传递能量,有离心泵、轴流泵和混流泵等类型。
开车顺序:
1、关闭出口闸阀
2、将水注入水泵,以排除进水管及泵内空气,可从泵体*引水杯注入清水,也可用真空泵注水(开动真空泵,排除水泵及管内气体在水充满水泵的同时,起动水泵,打开闸阀,停止真空泵)。
3、开启电动机(注意水泵的旋转方向)。
4、当电动机正常运转后,逐步开大闸阀,达到所要求的工况后,球铁混流泵采购价,调节填料松紧。若水泵运转,球铁混流泵,轴承温度等都正常,则可继续运行。
III. Starting
Sequence
1.Close the oulet
sluice valve.
2. Inject
water into pump to remove the air in water-in pipe and pump which can realized
by injecting clear water from the water diversion cup of the pump body end or
by vacuum pump(start the vacuum pump, remove the air from pump and pipes, start
the water pump when the pump is full of water, open the sluice valve, stop the
vacuum pump).
3. Start the
motor(pay more attention on the rotation direction of pump)
4. When the motor runs normally,球铁混流泵生产厂家, turn up the
sluice valve gradually, adjust the tightness of padding when gettng to the
required working condition.If the pump runs well, the temperature of bearing is
normal, and it can run sequentially.
7、填料发热
The padding is
hot
1、填料压得太紧或四周紧密度不够2、填料压得偏斜与轴磨损严重
1.The padding is
pressed too tight or the around compactness is not enough
2.The padding is
pressed deflected and the axile wears seriously
1、旋松压盖螺栓高速填料紧密度
2、松开压盖重新均匀地上紧
1.Loosen the gland bolts to adjust
2.Loosen the gland bolts and tighten it again.